Reset Brother TN-360 laser toner cartridge.
Brother laser printers are notorious for not recognizing when a new full toner ink cartridge is installed into the printer. Brother laser printer for the most part use a system of gears to read if a new cartridge was installed but sometimes it does not catch or “get the message” that a new cartridge was install. Please try the instructions below to reset the levels and clear any low ink error message you get.
For DCP Printer Series:
– Open the front cover.
– Press the Clear/Back button on the control panel. The display will read “Replace Drum 1. YES 2. NO” (DISREGARD THIS MESSAGE) Proceed to the next steep.
– Press the start button, press the up or down arrow key until “00” appears on the LCD display and then press OK.
– Close the front cover and the operation has now been completed.
For MFC Printer Series:
– Open the front cover.
– Press the Clear/Back button on the control panel.
– Press in order *,0,0.
– Close the front cover and the operation has now been completed.
For HL Printer Series:
– Open the front cover.
– Turn on the power switch while holding down the “GO” (Blue LED) button until all LEDs on the control panel light up. (approx. 5 sec- onds)
– Release the “GO” button and check that all LEDs are o .
– Press the “GO” button twice, pause then press the “GO” button six times for TN-330 (Standard Yield) Toner, or seven times for TN- 360 (High Yield) Toner.
– Close the front cover and the operation has now been completed.
